General Guidelines - Toolland AC06 Manual Del Usuario


Do not try to open the housing of the battery or battery charger.

Do not expose the battery and charger to full sunlight or high temperatures.

Acid may start to boil. This is not unusual, but in order to prevent accidents switch off the charger
and let the battery cool down. Acid gases are toxic. Do not inhale!

Charging has to take place in a well-ventilated area.

Charging batteries with a higher capacity may damage the charger.

Always handle batteries with care.

When smoke or stench from scorched insulation is noticed, immediately unplug the charger from the
mains.

There are no user-serviceable parts in the charger. Contact your dealer for spare parts if necessary.
3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

Protect this device from shocks and abuse. Avoid brute force when operating the device.

Protect the device against extreme heat, dust and moisture.

Familiarise yourself with the functions of the device before actually using it.

All modifications of the device are forbidden for safety reasons.

Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
4. Features

overload protection (for charger)

for various motor cars, vans and light trucks

included accessories:
charging cable (1.5 m + 1.5 m)
o
two clamps
o
2 replaceable spare fuses
o
5. Overview
Refer to the illustrations on page 2 of this manual.
A
red LED
B
yellow LED
6. Preparation

Disconnect the battery from the vehicle before charging. To do this, first remove the negative pole
connection, and then proceed with the positive pole connection.

When applicable (non-sealed battery), check the level of the battery acid. When necessary, add
distilled water.

Clean the poles with a steel brush or sandpaper.

Make sure the battery charger is not connected to the mains.

Connect the positive clamp of the battery charger (red) with the positive pole (+) of the battery.
Make sure the clamp is secured tight.

Connect the negative clamp of the battery charger (black) with the negative pole (-) of the battery.
Make sure the clamp is secured tight.
7. Operation

The status of the charging process is indicated by 3 LEDs on the front of the unit. Refer to the
illustration on page 2 of this manual.

When the battery charger is correctly connected to the battery, the red LED [A] lights up.
V. 04 – 11/01/2018
Always check the condition of the cables and clamps before using the
battery charger. Do not use when damage is noticed!
AC06
C
green LED
D
fuse with indicator (20 A)
4 ©Velleman nv