Basic Operation; Ups On/Off - Tripp-Lite LCDT Serie Manual Del Propietário

Basic Operation

UPS ON/OFF

• Plug the UPS into a live, grounded outlet.
The LCD display will illuminate, the battery charger will engage as necessary and the SURGE PROTECTED outlets will begin passing
power.
• Plug equipment into the UPS: Your UPS is designed to support electronic equipment only. You will overload the UPS if the total
VA ratings for all the equipment you connect to the "Battery, Surge and Noise Protected" outlets exceed the UPS's Output Capacity.
To estimate your equipment's power requirements, look on the nameplate. If the equipment is listed in amps, multiply the number
of amps by 120 to determine VA, (Example: 1 amp x 120 = 120 VA). Your UPS is fully loaded when the display indicates 100%
load.
• Turn the UPS on: Press and hold the POWER
The BATTERY/SURGE PROTECTED outlets will begin passing AC line power. The UPS will automatically recharge internal batteries as
needed. Once turned on, your UPS is ready to protect connected equipment from blackouts, brownouts, overvoltages and transient
surges.
• Turn the UPS off: Press and hold the POWER
12-12-069-93-327C.indb 4
BUTTON for one second. The UPS alarm will beep once briefly.
BUTTON for one second.
4
12/6/2012 9:28:35 AM