Previous Information - Baxtran ARD Manual De Usuario

ARD
ASSEMBLY OF THE SET OF THE HELM
With the Axis and chain
installed, it can be used after
pressing the bar down and
pulling out the thrust plunger
LEVER OF REGULATION
The lever of regulation has three positions (ascending, medium and descending)
ascending
media
descending
When the hand pallet is not, the helm must be placed in medium position. The position of the lever of re-
gulation has been adjusted in factory, if it is necessary to change it, the customer must follow the following
steps:
1. If you push the lever downwards in medium position, the forklifts will go upwards, then the user must
turn around the unload screw following the movement of the hands of the clock, the forklifts will not rise
when you press the lever.
2. If you push the lever downwards in medium position, the forklifts will go downwards, and then the user
must turn the unloading screw following the movement of the hands of the clock until the forklifts do not
go downwards when you press the lever.
3. If the user has the lever of regulation in a descending position, the forklifts do not go downwards, then
Manual de usuario
bar
chain
--
--
--

0. PREVIOUS INFORMATION

After the axis pierces, knock
05 mm pin into pinhole
After the axis pierces, the
chain pass through this hole
ES FR ENG
23