Emitters; Emitters Programming (Learn); Erase Emitters; Operating Adjustments - DIMOEL moov-b400 Manual De Instrucciones

5. EMITTERS

5.1 Emitters
Emitters operate in step by step mode with a single
pushbutton.
The control circuit can store up to 25 emitters.
One pulsation opens, the next stops, the next closes,
the next stops, and so on.
You can program any of the four transmitter
pushbuttons.

5.2 Emitters programming (learn).

Press the AN1 button on the control circuit.
The LEARN light on the control board lights.
Press the transmitter key twice to activate the motor. The LEARN
light is switched off with the first pulsation and for 4 seconds with
the second pulsation.
Programming is over. The system works with the transmitter.

5.3 Erase emitters

The deletion process removes all emitters from the motor memory.
Individual transmitters can not be erased.
Press the AN1 button on the control circuit and keep it pressed. The
LED2 light comes on. Release the button when the light is off.
The emitters have been erased.
Note: After installing or powered off the motor, make a complete
maneuver (open and close) pressing the emitter button or an
external button. The control board will memorize the distance and
the soft stop function will be activated in the next maneuver.

6. OPERATING ADJUSTMENTS

6.1 Programming Micro-switches

In the circuit there is a block of 6 micro switches to program
functions.
Micro-switch 1, close dalay. If ON, motor 2 startsclosing 3
segundos before that motor 1.
11