Troubleshooting - DIMOEL moov-b400 Manual De Instrucciones

7. TROUBLESHOOTING

Problems
The gate cannot open
or close normally, and
LED does not light.
The gate can open but
cannot close.
The door don't finish
the distance.
Remote control doesn't
work.
Press OPEN, CLOSE
button, the gate is not
moving, motor
noise.
Leakage
tripped.
Remote
working distance is too
short.
The gate moves to the
middle position to stop
or reverse.
13
Possible Reasons
1.The control board power is off.
2.Fuse is burned.
3.Control board power wiring with
problem.
1.Photocell wiring with problem.
2.Photocell
problem.
3.Photocell is blocked by objects.
4.Sensitivity of obstacle is too
high.
1.The power regulation is low.
2.The door
smooth.
1.Battery level of the remote
control is low.
2.Remote control learning is not
completed.
The motor is unblocked.
has
switch Power supply line short circuit or
motor line short circuit.
control
Signal is blocked.
1.Motor output force is not
enough.
2.Sensitivity of obstacle is too
high.
3.Gate meets obstacle.
1.Switch on the power supply
of control board.
2.Check the fuse, change the
fuse if burnt.
3.Re wiring according to
instructions.
1.If not connect photocell,
please make sure that the IR
and COM short circuit; if
connect
please make sure the wiring
mounting with
is correct and the photocell is
N.C.
2.Make
photocell mounting position
can be mutually aligned.
3.Remove the obstacle.
4.Reduce the sensitivity of
obstacle.
1.
regulation.
2.
movement isn't
between X and Y, and the
gate movement manually is
soft.
1.Change the remote control
battery.
2.Re-conduct remote control
learning.
Block the motor with the
blocked keys.
Check wiring.
Connect external receiver
antenna, 1.5 meters above
ground.
1.Check
transformer power is normal,
if
transformer.
2.Adjust the VR1, VR2.
3.Remove the obstacle.
Solutions
infrared sensor,
sure that
Increase the power
Check the distances
whether
not, change
the
the
the