Install The Light Bulbs (Bpdc1 Series); Install The Filters - Broan BPDC1 Serie Manual De Instalación,Utilización Y Cuidado

Install the Light Bulbs
(BPDC1 Series only)
Install two shielded Halogen Bulbs (120 V, 50 W max., MR16 or PAR16 with GU10 base), not
included.
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent
the risk of personal injury, only install shielded halogen lamps. Also, never install a cool
beam, a dichroic lamp, a lamp not suitable for use in recessed luminaires or identified for
use in enclosed fixtures.
BULB LEADS
1 ] Align the bulb leads with the small indentations located on the border of the lamp location on
hood (see inset above), then install the bulbs by placing the bulb leads into their grooves in
the socket.
2 ] Gently push upwards and turn clockwise until secure.
NOTE: The Suction Cup Tool (included with hood) can be used to install and remove light bulbs.
Press suction cup tool on bulb and rotate counterclockwise to remove bulb or clockwise
to install bulb.
Most GU10 LED replacement bulbs commonly found in the market are not designed
for use in a cooking environment and might not perform as advertised. Their usage
with this product is not recommended.

Install the Filters

Ducted Installation Only:
Re-install grease filters removed in step 3 , page 9, under "Prepare the Hood" .
Non-ducted Installation Only:
Purchase two non-ducted filters from your local distributor or retailer (see product specification
label for filter type). Attach the non-ducted filters following instructions packed with the non-
ducted filters.
! WARNING
BULB LEAD
GROOVES
(IN SOCKET)
INDENT
! CAUTION
SUCTION
CUP TOOL
21