Remove Grease Filters; Adjust The Hood Mounting Brackets; Install The Hood - Broan EW46 Serie Manual De Instalación,Utilización Y Cuidado

6. REMOVE GREASE FILTERS

Lay the back side of the hood flat on a table. Use a piece of cardboard to
avoid damaging the table or the hood.
To remove the grease filters, pull down on the metal latch tab and tilt each
filter downward. Set filters aside.

7. ADJUST THE HOOD MOUNTING BRACKETS

Both hood mounting brackets, located on top back corners of the unit, are
factory sent in down position (A). For each bracket, loosen both retaining
screws, then lift up bracket as shown in B, then tighten the screws.

8. INSTALL THE HOOD

BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
DO NOT REMOVE the protective plastic film covering the decorative flue (upper & lower) yet.
1. Align the hood with the center line previously marked on the wall. Gently
lower the hood until it securely engages the screws on the wall.
2. Level the hood and completely tighten the screws on the wall.
3. Secure the hood to the wall by inserting 2 M4 x 38 Phillips 9 mm round head
mounting screws and 2 washers in the lower back of the hood (see back view
at right). Tighten both screws completely.
HD1148
BACK CORNER
A
HD1160
WARNING
!
CAUTION
HD1164
5
BACK CORNER
B
H
OLE LOCATIONS