Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
We appreciate the deference to our brand and we hope will be of great use the newly acquired charger-starter. This
manual contains information and warnings necessary for proper use within the maximum safety for the operator. In
case of misunderstanding or concerns about this manual, please get in touch with us. Please refrain from performing
any work on the starter (only technically qualified personnel authorized by Solter Soldadura S.L. can do it). The
manufacturer declines all responsibility for negligent practices in the use and / or handling. This manual should be
attached and stored with the acquired starter. It is the responsibility of the people who use and repair, the product will
not fail to meet the requirements of these standards.
OPERATIONAL GUIDANCE
Charging mode:
Before charging, check that the fuse is in good condition and connect the charger to the mains (230Vac).
Connect the red clamp in the position of + 12V or + 24V depending on the battery to be charged.
Select the desired charging speed depending on the battery to be charged (minus Ah, means lower charging
speed/amperage):
The model with rotary selector will automatically start the charging cycle after selecting the position, while in the
two-switch model, the "CHARGE" switch must be activated after selecting the charging speed:
A microprocessor controlled device will start charging the battery and then activate the maintenance cycle.
Publicidad
