Publicidad
Idiomas disponibles
Idiomas disponibles
The charger has a built-in electronic protection against short-circuit, reverse polarity or incorrect voltage to the battery.
In this case, the three LEDs (red, yellow and green) will lit intermittently at the same time indicating an ALARM.
To work properly again, disconnect the positive and negative clamps of the battery and the connection cable from the
mains. After a few minutes, connect correctly again.
During the charging of the battery, the current indicated on the ammeter decreases slowly according to the W
characteristic curve (DIN 41774). When the charging is completed, the ammeter will indicate current values equal to
zero.
The indicated values in the following example image (digital ammeter) are purely indicative and should not be
understood as specific references:
Publicidad
