Zanussi ZWT 71401 WA Manual De Instrucciones página 26

A
600 mm
min.
596 mm
560 mm
min.
820 mm
75 mm
60 mm
100 mm
Preparation and assembly of the door
The machine is originally prearranged for the assembly of
a door opening from right to left.
In this case it is sufficient to screw inthe hinges (1) and
the counter-magnet (6) provided with the appliance, at the
right level (Fig. B).
B
6
1
2
a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the height of the adja-
cent furniture's base.
26
555 mm
176,5 mm
416 mm
170 mm
7
3
5
C
818 mm
b) Hinges
To mount the hinges it is necessary to drill two holes (dia.
35 mm, depth 12.5-14 mm depending on the depth of
door furniture) on the inner side of the door. The distance
between the holes hobs fixing centres must be 416 mm.
The distance (B) from upper edge of the door to the centre
of the hole depends on the adjacent furniture's dimen-
sions.
The required dimensions are given in the picture C.
The hinges will be fixed to the door by means of screws
for wood (2-Fig. B) supplied with the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by means of the M 5x15
screws (3-Fig. B). The hinges can be adjusted to compen-
sate for possible uneven thickness of the door.
To align the door perfectly it is necessary to loosen the
screw (3-Fig. B), adjust the door and tighten the screw
again.
4
d) Counter-magnet (6)
The appliance is prearranged for a magnetic closure of the
door.
To enable a correct operation of this device, it is necessa-
ry to screw the counter-magnet (6) (steel disk + rubber
ring) into the inner side of the door. Its position must cor-
respond to the magnet (4) on the appliance (see picture
D).
16-22 mm
Ø 35 mm
14 mm
595-598 mm
B
C
416
mm
22±1,5 mm
www.zanussi.com