Use - Drying - Zanussi ZWT 71401 WA Manual De Instrucciones

Important! The selected delay can be changed only after
selecting the washing programme again.
The Delay Start can not be selected with DRAIN
programme.
Start the programme by pressing button 8
To start the selected programme, press the button 8, the
green pilot light of the button 8 stops blinking.
To interrupt a programme which is running, press the but-
ton 8: the green pilot light starts blinking.
To restart the programme from the point at which it was
interrupted, press the button 8 again. If you have chosen a
delayed start, the machine will begin the countdown. If an
incorrect option is selected, the red pilot light of the but-
ton 8 blinks 3 times and the message Err is displayed for
a few seconds.
Altering an option or a running programme
It is possible to change some options before the pro-
gramme carries them out.
Before you make any change, you must PAUSE the appli-
ance by pressing the button 8.
Changing a running programme is possible only by reset-
ting it. Turn the programme selector dial to O and then to
the new programme position. Start the new programme by
pressing the button 8 again. The washing water in the tub
will be not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme which is run-
ning, the corresponding green pilot light starts blinking.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to
is running.

Use - Drying

Drying only
Warning!
The recommended load size is 3 kg for cottons and linen,
and 1,5 kg for synthetic items.
By pressing Drying Time button it is also possible
to dry up to 4 kg of cotton items (see the «Drying
Programme » table).
Warning!
www.zanussi.com
to cancel a programme which
You can select now a new programme.
At the end of the programme
The machine stops automatically. Three blinking 0.00 ap-
pear on the display and the pilot light of button 8 goes off.
Some acoustic signals sound.
If a programme or an option that ends with water left in the
tub has been selected, the door remains locked to indicate
that the water must be emptied out before opening the
door.
Follow the below instructions to empty out the water:
1. Turn the programme selector dial to O.
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the
relevant button.
4. Press button 8.
At the end of the programme, the door is released and can
be opened. Turn the programme selector dial to O to
switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Stand By: If your laundry is not removed within 10 mi-
nutes after the programme is finished, the back light of the
display switches off and the energy saving system will be
enabled. Only the pilot light of the button 8 is blinking to
indicate that the appliance has to be switched off. By
pressing any button the appliance will come out from the
energy saving status and you can set another programme
or switch the appliance off.
The water tap must be open and the drain hose must be
positioned in the sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin speed al-
lowed for the type of laundry in order to obtain the
best drying performances.
3. Select the drying programme for Cottons or Synthet-
ic in the Drying sector of the programme selector di-
al.
9