Set The Speed Range Switch; Changing Needle; To Remove And Attach The Foot Holder; To Remove - Sears Kenmore 385.16524000 Manual De Instrucciones

Set the Speed Range Switch
Your machine has two ranges of speed - a low range for
slower, intricate work and high one for faster, general work.
On the low setting the machine will sew no faster than
approximately two-thirds the speed of the high one, even
when the foot control is fully depressed.
NOTE:
It is advisable not to change the speed range switch while
machine is running.
Changing
Needle
(_ Needle clamp screw
_) Needle clamp
[] Turn off the power switch.
Raise the needle to its highest position by turning the
handwheet counterclockwise, toward you, and lowering
the presser foot. Loosen the needle clamp screw(_l_by
turning it counterclockwise. Remove the needle from the
needle clamp _).
[] Insert a new needle into the needle clamp(_)with the
fiat side to the rear. When inserting the needle into the
needle clamp (_), push it up as far as it goes. Tighten
the needle clamp screw (_) firmly by turning it clockwise.
[] To see if the needle is good, place the flat side of the
needle onto something flat (needle plate, glass, etc.).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
S
To Remove and Attach the Foot Holder
_t_Thumb screw
Foot holder
Presser bar
• To remove
Remove the thumb screw _1_ by turning it counterclockwise
with a screwdriver.
• To attach
Match the hole in the foot holder _with the threaded
hole in the presser bar _. Fit the thumb screw _l_into
the hole. Tighten the screw _l_by turning it clockwise with
a screwdriver.
Changing
Presser Foot
_t_Snap-on button (red button)
Groove
Pin
• TO remove
Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the red button _t_on the back of the foot holder.
• To attach
Place the selected presser foot, so that the ping on the
foot lies just under the groove _ on the foot holder. Lower
the presser bar to lock the foot in to the place.
S
[]
HIGH
Flat side
Lade piano _ Needle I
M6plat vers Aguja
Ague
[]
[]
J
J
J
J
10