Blue I HydroGuard HG-302 Manual De Uso página 147

6.2.3.3 Technician Menu
The following table lists the parameters in HydroGuard's Technician menu:
Menu # Name
51 Cl P factor
52 Cl pump period
53 Cl pump freq
54 Cl Overfeed Time
55 Cl Averaging
56 Cl < 0.1 Alarm
57 pH p factor
58 pH pump period
59 pH pump freq
60 pH Overfeed Time
61 pH balance type
62 Flow Sensor
63 Flow Rate
64 Celsius/Farh
65 Temp Hysteresis
66 Turbidity
67 NTU wiper interval
68 Minutes
69 Hour
70 Day
71 Month
72 Year
73 Recording Interval
74 Tot Chlor ON/OFF
75 Chlor Ratio
76 Address
77 Software Version
78 Operator Password
79 Technical Password
Proportional Factor for Cl Relay 1
1 Pump cycle (on +off time) for Cl Relay 1
Cl pump max pulses/min, 0 for on/off pump
Will open relay 1+2 if Cl feeding continuously for this time
Displays an average of the last 4 Cl readings
If Cl drops below this level, Alarm indicated and Opens Cl Relay 1+2
Proportional Factor for pH Relay 3
1 Pump cycle (on +off time) for pH Relay 3
pH pump max pulses/min, 0 for on/off pump
Will open relay 3 if pH feeding continuously for this time
To Select if Acid of Base is being added to adjust pH
Will turn display of Flow rate on/off (only use if flow meter connected)
Choose between metric and US units
Choose between metric and US units
Value in degrees, below set-point which will close Temp Relay 6
Turns Turbidity Module ON/OFF (optional module)
Interval for Turbidity Module Wiper to clean glass (optional module)
Current Time for Data Logger
Current Time for Data Logger
Current Time for Data Logger
Current Time for Data Logger
Current Time for Data Logger
Time interval between readings stored on the on-board data logger
Turns the total Cl testing ON or OFF
Ratio of Free Cl tests to Total Cl tests
Controller ID - used with external communication
Current software version
Change operator password
Change technician password
61
Description