Fuse Replacement; Wireless Remote Control; Programmable Color Selection - Chauvet DJ Firebird Led Guía De Referencia Rápida

Firebird™ LED QRG
AC Power

Fuse Replacement

Configuration
(Standalone)
Control from the
Display
Wireless Remote
Control
Programmable
Color Selection
Firebird™ LED has a fixed power supply that works with either a voltage of
120 VAC, 60 Hz or 240 VAC, 50 Hz.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Disconnect the product from power before replacing the fuse.
Set the product without a controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on using the power switch.
Press the <MENU> and <ENTER> buttons simultaneously to activate the
selection on CH-1.
The display will still show ADDR while in Standalone mode.
To trigger the simulated flame and activate the color program using the wireless
remote control, do the following:
1. Plug the wireless receiver into the Wireless Remote port on the side of the
Firebird™ LED.
2. On the wireless transmitter, press the button assigned to the color program
(1–4). The Firebird™ LED simulated flame turns on and activates the color
program.
To select either the preset color program or one preset color to illuminate the
simulated flame using the wireless remote control, follow the instructions below:
1. Press <MENU> repeatedly until CH-1–CH-4 shows on the display. Select
CH-1, CH-2, CH-3, or CH-4 to choose that color program.
Note: The color program numbers correspond with the numbered buttons on
the wireless transmitter.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select Co 1–Co17 (to choose one of fifteen preset
colors, fade, or snap).
4. Press <ENTER>.
5. Repeat steps 1–4 to configure the other buttons.
The Geyser™ Wireless Remote Control buttons 1–4 trigger the options set in
the color programs CH-1–CH-4, respectively.
5
EN