EHEIM incpiria marine 230 Manual De Instrucciones página 18

English
‧ The electrical data of the LED light must match the data of the power
mains. This data is found on the type plate, the packaging and in these
instructions.
‧ The distance from the underside of the light to the highest water mark
must be a minimum of 15 mm.
4. Preparation
Unpacking
‧ Carefully remove all components from the packaging and make sure that nothing is missing or damaged.
CAUTION! Risk of breaking the aquarium glass base.
The aquarium must not be placed on the connections b (⌦B).
▶ Leave the aquarium on the transport sections.
5. Assembly
Location
‧ Avoid direct sunlight, and not too much daylight!
‧ Keep the aquarium away from heat sources.
‧ Keep the aquarium away from electrical equipment.
‧ Be aware of any nearby mains connections.
CAUTION! Material damage.
▶ Ensure that the surface is level and stable.
▶ Be mindful of the floor load provided by the entire weight.
Setting up and aligning the base cabinet (⌦A)
1. Place the base cabinet in the desired position.
2. Align the base cabinet horizontally using a spirit level.
A stand can be used for horizontal alignment. Ensure that the stand rests fully on the surface.
Placing the aquarium on top (⌦C)
DANGER! Personal injury or material damage.
The aquarium must not be transported or carried when in its filled state.
CAUTION! Material damage.
No foreign bodies, mats or bases must be placed between the aquarium and base cabinet.
▶ Thoroughly clean the top side of the base cabinet and the lower side of the aquarium base.
▶ Remove any foreign bodies, mats or bases.
1. Place the empty aquarium on the base cabinet. Ensure that the connections a lie in the section of
the base cabinet's top side.
18