Bremshey Sport CONTROL-S Manual Del Usuario página 4

Connect the meter wire from the frame to the
meter wire in the front tube. Push the front tube
inside the frame tube: beware not to damage the
console cable! Attach the front tube with six screws
tight.
PEDAL CRANKS
Place the rear end of the left pedal crank on the left
rear shaft. Next place the washer and locking nut
on the shaft. Tighten the locking nut fingertight.
Repeat the procedure on the right side.
Push the front end of the left pedal crank inside
the lower end of the left handle. Attach the crank
to the handle with four screws fingertight. Repeat
the procedure on the right side.
Tighten all cranks locking nuts and screws well and
push the plastic end caps on the nuts and screws.
PEDAL CRANKS (Product version 1)
NOTE!
Place the long metal bushing on the left rear shaft,
then the rear end of the left pedal crank. Next place
the short metal bushing, washer and locking nut
on the shaft. Tighten the locking nut fingertight.
Repeat the procedure on the right side.
STATIONARY HANDLEBAR
4
Thread the handgrip pulse cables inside the front
tube and pull them out through the top end of the
tube. Attach the stationary handlebar with two
screws. Beware not to damage the cables!
NOTE!
Place the cover parts over the handlebar
attachment point and tighten with a screw.
HANDLES