Warning Buzzers And Procedures To Follow - Max REBAR-TIER RB401T-E Manual De Instrucciones E Instrucciones De Seguridad

13.WARNING BUZZERS AND PROCEDURES TO FOLLOW

This tool sounds warning buzzers for the conditions described below. If the buzzer sounds, follow
procedures according to the conditions described below.
• If the conditions described below occur, set the Main switch (Fig.1.e) at "OFF" and remove
the Battery pack (Fig.1.5) before following procedures.
• Do not touch the tying or rotating parts at the tip when setting the Main switch at "ON" under
any circumstances.
<Buzzer types and procedures to follow>
Buzzer types
Once (Pi, pi, pi...)
Twice (Pipi, pipi, pipi...)
Three times (Pipipi,
pipipi, pipipi...)
Continuous high pitched
beep (Piii...)
Continuous high & low
pitched chime (Pii poh
Pii poh...)
Single-short beep (Popi)
WARNING
Possible cause
Wire is jammed in the Hook
(Fig.1.f)
Motor is hot
Main switch is set at "ON" with the
Contact switch pressed.
Low battery
Battery pack is not fully inserted
Tiewire is used up
Tiewire is jammed
Dust the sensor in Magazine.
Tool is at an angle.
Internal structure; defect in internal
driving mechanism
Check whether the wire or anything else
is caught in the Hook
Let the tool rest and cool down
Set the Main switch at "ON" without the
Contact switch being pressed.
Charge the Battery pack
Insert the Battery pack properly
Replace with a new Tiewire
Open the Magazine cover (Fig.10.n)
and fix the jammed wire
Dust the sides of sensors and lenses
with water or cotton bud gently.
Tie with the tool facing directly
downward.
Immediately discontinue operation and
set the Main switch (Fig.22.e) at "OFF"
and remove the Battery pack
(Fig.22.5) before consulting. Then
contact the dealer where the tool was
purchased or MAX CO., LTD.
authorized distributors.
20
Procedures to follow