Net Setup; Network Status - MSA Galaxy Manual De Instrucciones

• Cylinder 1
• Cylinder 2
• Cylinder 3
• If the Test Stand is using cylinder holders, the cylinder counts from
right to left:
• Cylinder 1 is the closest to the Test Stand
• Cylinder 2 is the next to the left
• Cylinder 3 is the last on the left
• Fresh Air is the top connection on the last installed cylinder
holder
• To change the gases on a particular cylinder:
NOTE: If background gases could be present, connect a zero air
cylinder (P/N 801050) to port #3 (the bottom port). This
requires a Test Stand with expanded solenoid capacity.
Use á, â, and ENTER (8 ) to select the correct cylinder;
•
select the new gasses in one of two ways:
1) By cylinder part number:
Use á, â, and ENTER (8 ) to select the desired
•
part number
2) Individually select each gas and the value in the cylinder.
• You can select up to five gases for each cylinder.
• If you have less than five gases, set the remaining gases to
NONE.

Net Setup

• This allows the user to configure the optional Network Interface.

Network Status

• This selection provides improved troubleshooting capability for
network use.
• A plus (+) indicates that a good connection is made to the Test
Stand or Network Interface located that side.
• A minus (-) indicates that no Test Stand has been found on that
side.
• Proper network operation will not occur unless all Test Stands are
communicating properly to each other and to the Network
Interface.
3-6