SpeedEPart Agri-Fab 45-04621 Manual Del Usuario página 7

sTeP 14:
(see FIGure 13)
• Insert the end of the flow control rod (5) with double
bend through the hole in the drive link bracket (Z) and
then twist the rod so that the end points down.
5
Z
5
FIGure 13
sTeP 15:
(see FIGure 14)
• Insert the other end of the flow control rod (5)
through the hole in the control arm on the flow control
assembly. Secure it with a 1/4" washer (N) and a 3/32"
x 3/4" cotter pin (I).
5
FIGure 14
sTeP 16:
•
•
•
Q
FIGure 15
sTeP 17:
•
•
•
•
N
I
FIGure 16
7
(see FIGure 15)
Assemble the adjustable stop (S) to the flow control
bracket using the 1/4" x 3/4" carriage bolt (F), a nylon
washer (L) and the wing nut (R).
Install the handle grips (Q) onto the handles.
Install the control grip (Y) onto the flow control arm.
R
L
S
F
(see FIGure 16)
Set the adjustable stop at "5" and move the control
arm back against it.
Slide the control bracket along the handle tube until
the flow plate in the bottom of the hopper is open half
way.
Tighten the bolts and nuts attaching the control bracket
to the handle tubes.
Make sure the flow plate will open and close
completely. Readjust if necessary.
SETTING "5"
Y
Q