Safety Information; Safety Symbols - koban KMD-20AFC-01 Instrucciones De Uso

OPERATING INSTRUCTION
PC INTERFACE
AUTO-RANGE DIGITAL MULTIMETER
KMD-20AFC-01
PC INTERFACE AUTO-RANGE DIGITAL MULTIMETER

SAFETY INFORMATION

The following safety information must be observed to insure
maximum personal safety during the operation at this meter:
Do not use the meter if the meter or test leads look damaged, or
if you suspect that the meter is not operating properly.
Never ground yourself when taking electrical measurements. Do
not touch exposed metal pipes, outlets, fixtures, etc., which might
be at ground potential. Keep your body isolated from ground by
using dry clothing, rubber shoes, rubber mats, or any approved
insulating material.
Turn off power to the circuit under test before cutting, unsoldering,
or breaking the circuit. Small amounts of current can be
dangerous.
Use caution when working above 60V dc or 30V ac rms. such
voltages pose a shock hazard.
When using the probes, keep your fingers behind the finger
guards on the probes.
Measuring voltage which exceeds the limits of the multimeter
may damage the meter and expose the operator to a shock
hazard. Always recognize the meter voltage limits as stated on
the front of the meter.

SAFETY SYMBOLS

Indicates operators must refer to the explanation in this
!
manual.
Indicates terminals at which dangerous voltage maybe
present.
SPECIFICATIONS
Safety: Designed to Protection Class III requirement of EN61010-1
over-voltage Category III (CATIII).
2
V 0407
www.grupotemper.com