Troubleshooting - cecotec CONGA 1490 Manual De Instrucciones

Remove the battery cover.
Remove the insulating tape on both sides of the battery and take it out.
Unplug the wire connector that links the battery to the robot.
Introduce the new battery and make sure the side with printed words is facing upwards.
Connect the cable from the battery to the robot.
Introduce the battery in the compartment.
Screw back the battery's cover.
Note: only use the original battery provided by Cecotec, the use of a different one could cause
product damage.

6. TROUBLESHOOTING

Error Reason
The power switch
1 is off while char-
ging
Left side free-fall
2 sen-sor error
Right side free-fall
3
sensor error
Front free-fall sen-
4
sor error
Left wheel off the
5
ground
Right wheel off the
6
ground
Left side an-ti-co-
7
llision sensor error
Right side anti-co-
8
llision sensor error
Front an-ti-colli-
9 sion sensor error
Solution Button dis-play
Check if the power The robot's display
switch is on or off and flash-es quickly
turn it on
Place the robot on a The robot's display
flat stable surface lights up in blue and
flashes quickly
The ro-bot's dis-
play lights up in
blue and flashes
slowly
Clean or un-block the The robot's display
front bumper lights up steady red
and blue
ENGLISH
Beeps
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
1 long beep
43