Installation; Scope Of Delivery; Selecting An Installation Site; Unpacking The Device - Sartorius Entris II Advanced Line BCA Instrucciones De Manejo

5

Installation

5 . 1

Scope of Delivery

Item
Device
Weighing pan
Shield disk (only analytical balance)
Pan support
Power supply unit with country-specific
adapters
Analytical draft shield
Dust cover
Operating Instructions
5 .2

Selecting an Installation Site

Procedure
Make sure that the following conditions are met at
t
the installation site:
Condition
Ambient conditions
Setup surface
Access to operation-
relevant parts
Quantity
1
1
1
1
1
1
1
1
Characteristics
Suitability tested (for
ambient conditions, see
Chapter "14 . 1 Ambient
Conditions", page 47)
− Stable, even surface
with little vibration
− Sufficient space for the
device (for device space
requirements, see
Chapter "14 . 1 0 Device
Dimensions",
page 50)
− Sufficient load-bearing
capacity for the device
and peripheral devices,
even when full (for
device weight, see
Chapter "14 . 1 1 Gross
Weight", page 50)
Convenient and safe
5 .3

Unpacking the Device

Procedure
Unpack the device .
t
NOTICE Danger of damage to the device from im-
t
proper handling! Do not lift the device by the draft
shield . Only lift the device by its base .
Install the device at the intended installation site .
t
We recommend keeping the original packaging to
t
return the device securely and appropriately, e .g . for
repairs .
5 .4 Installing the Weighing Pan
and Associated Components
Procedure
5 .5

Acclimatizing

When a cold device is brought into a warmer area: The
temperature difference can lead to condensation of hu-
midity in the device (moisture formation) . Moisture in
the device can lead to malfunctions .
Procedure
Allow the device to acclimatize for approx . 2 hours at
t
the installation site . Ensure that the device is discon-
nected from the power supply during that time .
Entris II Advanced Line Operating Instructions
®
Installation
Fully open the side
t
panel of the
analytical draft
shield .
If an analytical
t
balance is used:
Install the shield
disk, the pan
support, and the
weighing pan .
If a precision
t
balance is used:
Install the pan
support and the
weighing pan .
35