Capítulo 4. Wps Configuration; Pbc (Push Button Configuration) Method - Multilaser RE025 Manual Del Usuario

3. If the key entered is correct, you will successfully connect to the network as shown in Figure 3 21.
Capítulo 4. WPS configuration
WPS (Wi-Fi Protected Setup) function allows you to add a new wireless device to an existing network quickly.
If the wireless card supports Wi-Fi Protected Setup (WPS), you can establish a wireless connection between wireless card and
router using either Push Button Configuration (PBC) method or PIN method.
First, the WPS software should be installed. Insert the Resource CD into your CD-ROM drive. To continue, double-click My Com-
puter, and then double-click the CD/DVD drive where the installation CD was placed. Open RE025 folder, and double-click wps.
exe. Then you will see Figure 4.1.
38
Then, please follow the step-by-step instruction to complete the WPS installation. After that, WPS function can be enabled.
Here we will introduce two ways to configure the WPS.

4.1 PBC (Push Button Configuration) method

1. Firstly, press the WPS button of the router. There are two ways:
1) Press the WPS button directly on the front panel of the Router shown in Figure 4 2.
www.multilaser.com.br
F 3 21
igura
F 4 1
igura
F
igura
4 2