How To Set Up Machine Using The Program Display Panel; Important - Janome 1200D Manual De Instrucciones

F
G
L
How To Set Up Machine Using the Program
Display Panel
Turn the program selection dial and select the desired
program number.
NOTE:
Machine should not be threaded before setting the
machine up for the selected program. Cut and remove
all threads.
HINT:
Cut threads at looper and needle eyes and hand pull
threads away.

IMPORTANT:

Never press on foot control to sew out threads.
A
C
D
I
K
H
J
Program display
A.
Program selection dial
B.
Program number
C.
Differential feed ratio
D.
Stitch length in mm
E.
Needle position
F.
Cutting width dial position
G.
Position of upper knife
H.
2-thread converter - up/down
I.
Overlock cover or sewing table
J.
Foot lever position
K.
Position of needle plate setting knob
L.
Chain looper tension dial position (brown)
M.
18
B
E
M