Prima PP 35 Manual De Uso página 7

FUNCTIONS
1.ON/FF Switch – In the ON position the machine is ready for normal operation. All system
control circuits are activated. OFF position deactivates control circuits.
2.Output Current Knob - Adjusts the cutting current supplied by the machine according to the
thickness of material/speed.
3.Green LED– Turns ON when input voltage is applied within normal range – blinks slowly
when input voltage goes above 260Vac, or below 180Vac.
4.Red LED–Turns ON when torch is triggered. Blinks quickly during 3 second safety pre-fl ow
prior to pilot arc ignition. Blinks slowly if cutting arcs not initiated after 3 second pilot arc
ignition.
5.Yellow LED– Turns ON when the thermal protection is activated. Blinks slowly when the
under pressure protection is working (the pressure is under 3,8 Bar).
6. Air regulator - Adjusts the input air pressure - pull upward to unlock - nominal air pressure
setting is 4,5 Bar. Note: the regulator should never be set above 6 Bar.
7. Gauge
8. Compressed air connection
9. Input cord
10. Work cable with clamp
11. Torch
7