Operating Instructions - Skil SD561801 Manual Del Propietário

OPERATING INSTRUCTIONS

WARNING
never immerse your tool, battery pack or power supply in fluid
or allow a fluid to flow inside them.
fluids, such as seawater, certain industrial chemicals, bleach or
bleach-containing products, etc., can cause a short circuit.
WARNING
replaced .
Use of this product with damaged or missing parts could
result in serious personal injury.
To Charge the Battery (Fig . 2)
NOTICE:
Charge before first use. The screwdriver is shipped
partially charged; fully charge the battery before first use.
Optimum performance can be reached by recharging the tool for
about 3 hours. It is not recommended that the tool be recharged for
more than 24 hours after each use.
For use only with SKIL SC536301 (Output: 5V 1A) power supply or
Listed/Certified Information Technology (Computer Equipment).
WARNING
certified.
Failure to obey this warning could cause battery damage
and serious personal injury.
a) Insert the USB interface of the USB charging cable into the power
supply.
b) Insert the charging plug into the charging port, making sure that
they are properly connected.
c) Connect the power supply (together with USB charging cable) to
a power outlet. The charging indicator light on the screwdriver will
flash green to indicate that the tool is charging.
NOTICE: The tool will not operate when the trigger switch is
depressed during charging.
20
To reduce the risk of fire, personal injury,
and product damage due to a short circuit,
If any parts are damaged or missing, do not
operate this product until the parts are
Never charge the tool with any power
supply or power source that is not listed/
Corrosive or conductive