Installation; Required Tools; Initial Conditions And Checks; Securing The Elements - Erreka VIVO-D103 Manual Del Instalador

Ocultar thumbs Ver también para VIVO-D103:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION

1

REQUIRED TOOLS

Set of screwdrivers
Electrician's scissors
Tape measure
2

INITIAL CONDITIONS AND CHECKS

Initial installation conditions
Ensure the operator is correctly installed in the
door.
Environmental conditions
This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation
Ensure the direct current connection and installation fulfil the following requirements:
• The nominal voltage of the installation must
coincide with that of the control board.
• The installation must be able to support the
power consumed by all the automatic key
devices.
• The installation must be earthed.
• The electrical installation must comply with
low voltage regulations.
3

SECURING THE ELEMENTS

1 Choose a location for the control board, taking as a
reference the figure shown in "Elements of the
complete installation" on page 39.
The height from the ground must be
sufficient as to be out of the reach of children.
The attachment surface must withstand the
weight of the control board.
2 Make two holes and attach the control board with
appropriate screws.
44
Installation Manual
Marker pencil
Electrical drill and broaches
Use the electrical drill in line with the user
manual.
It is necessary to have a direct current of
230Vac, 50Hz with earth connection.
Check that the admissible environmental
temperature range for the control board is
suitable for the location.
• The installation elements must be properly
secured and in a good state of conservation.
• The direct connection point must be high
enough to be out of the reach of children.
If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic key device.
3 Attach the other elements of the installation in line
with the corresponding instructions.
4 Position the ducts for the cable, securing firmly
using appropriate means.
If pushbuttons are installed to operate the
installation, we recommend installing them
out of the reach of children to prevent them
being played with (minimum recommended
height 1.6 m).

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Adb30

Tabla de contenido