Troubleshooting - cecotec CONGA 990 Serie Manual De Instrucciones

ENGLISH
Use a dry cloth to clean the charging terminals on the bottom of the robot and on the charging
base.
BATTERY
• Remove the battery and store it in a safe and dry place if the robot is not going to be used
for a long time.
• If a battery leakage is found, remove the battery and clean the compartment.
• If the battery needs to be changed, contact the Technical Support Service of Cecotec for
advice or follow the below steps:
1. Remove the screw on the battery cover; take off the cover.
2. Pull out the cable between the robot and the battery, then take out the battery.
3. Insert the new battery's cable and screw the battery cover.

6. TROUBLESHOOTING

Robot status
Charging
Charge completed
Robot error
Low battery
Cleaning
ALARM
When an error occurs to the robot, it will indicate it through the red light (steady or blinking)
and a series of beeps, which will vary depending on the error:
30
Light indicator
Blinking green/blue light
Steady green/blue light
Steady or blinking red light
Steady orange/red light
Steady green/blue light