Best CC6 Serie Instrucciones De Instalación página 6

4. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are especially designed to protect the exterior base of the custom hood.
Refer to the table below to find the right liner model number according to the width of
the custom hood nominal width. To view specific model information, including depths
for each liner model, visit www.BestRangeHoods.com, www.BestRangeHoods.ca, or
contact Technical Support (phone number listed on front cover).
To install, see instruction packed with custom hood liner.
NOTE: The liner must be installed before the insert.
5. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the custom hood, using the dimensions
shown at right.
NOTE: Keep in mind that the unit exterior flange is 3/4'' .
6. REMOVE FILTER
Rest the power pack on a table. Remove tapes on filters. Lift filters from power pack by pushing
them towards the back and rotate, then set filters aside.
C
USTOM HOOD
L
INER MODEL
NORMINAL WIDTH
ALCC630SB 30"
ALCC636SB 36"
ALCC642SB 42"
6
HA0067A
26¾"
HD0340A
HD0366
13³/ "
8