Installation & Mounting; Mounting - Rointe KYROS KRI0330RAD2 Manual De Instrucciones

KYROS
In ON mode you can increase or decrease the brightness of the screen by using the
buttons.
You can change the "Standby" mode brightness by pushing the button
to the "STAND-BY" position. You can then adjust the brightness by pushing the same
keys.
To finish the programming wait for 10 seconds without pressing any buttons.
2. INSTALLATION & MOUNTING
The radiator must never be installed immediately below a power point.
In bathrooms, the radiator must never be installed where the switches and other devices may
be within the reach of someone in the shower or bathtub.

2.1. Mounting

The KYROS radiator works by means of natural air convection (Figure 1). In order to achieve
optimal functioning and an even distribution of heat, the lower part of the radiator, once
mounted on the wall, must be at least 10 to 12 cm from the floor, and 30 cm at the most.
Fig. 1
8
M i n i m
1 0 c m
M i n i m
u m
1 0 c m
.
M i n i m
1 0 c m
Fig. 2
and
to move the frame
and
u m
.
M i n i m
u m
1 0 c m
.
u m
.