Message For Replacing Mechanical Unit; Micr Printing (Factory Installed Option); Cleaning The Micr Mechanism - Epson TM-J7000 Manual Del Usuario

Note:
Do not use the CLEANING button unless there is a problem with print
quality. Unnecessary cleaning will waste ink.
Do not turn off the power or open any covers while the POWER LED is
flashing.

Message for Replacing Mechanical Unit

The following message will be printed every time the printer is
turned on when the mechanical unit (pump unit) is near the end of
its life. Please follow the instructions in the message.
Caution: The pump unit must be replaced.
Contact a qualified service person.

MICR Printing (Factory installed option)

CAUTION:
Do not insert checks with staples in them. This may cause paper jams,
MICR reading errors, and damage to the MICR head.
Never open the roll paper cover while the MICR reader is being used.
Be sure the checks are flat, without curls, folds, or wrinkles.
Do not use multipart checks.
1. Wait until the CUT SHEET LED blinks. Then insert the check
face up with the right side of the check against the right side of
the paper guide as far as it will go. Be sure that the MICR
characters are on the right, as shown by the arrow in
illustration L.
2. The printer will detect the check and start drawing it in. When
the printer starts drawing it in, let go of the check immediately.
When the printer ejects the check and the CUT SHEET LED starts
blinking again; remove the check by pulling it straight up; do
not pull it at an angle.

Cleaning the MICR Mechanism

Approximately every 12 months clean the MICR head with a
moistened cleaning sheet.
Use the following or an equivalent commercially available cleaning
sheet:
PRESAT brand (KIC) "CHECK READER CLEANING CARD."
TM-J7000/J7100 User's Manual 11
English