Installation; Mounting The Unit On A Wall - Yamaha MusicCast YAS-306 Manual De Instrucciones

Installation

The unit can be installed on a TV stand or mounted on a wall.
It is equipped with remote control sensors positioned to support installation on a TV stand or mounting on a wall.
Installing the unit on a TV stand, etc.
Position the unit so that the keys are on the far side of the unit.
Remote control sensor (front panel)
About the TV remote repeater
The unit receives signals from the TV's remote control via the remote control sensor
located on the front panel. It then transmits these signals from the TV remote repeater
located on the rear panel. See page 8 in the Owner's Manual for more information.
TV's remote control
PREPARATION ➤ Installation
10
En
Cautions
• Do not stack the unit and a BD player
or other device directly on each other.
Doing so may cause a malfunction
due to vibrations.
• Do not hold the speaker portion
(fabric parts) on the front and the top
of the unit.
• The unit contains non-magnetic
shielding speakers. Do not place
magnetically sensitive items (hard
disk drive, etc.) near the unit.
• Depending on your installation
environment, it may be better to
Keys
connect the unit and external devices
before installing the unit.
TV remote repeater
More than 5 cm
TV remote control sensor

Mounting the unit on a wall

Mount the unit on the wall so that the keys face upwards. Follow the instructions
on page 9 in the Owner's Manual when mounting the unit on a wall.
Keys
Remote control sensor
(top panel)
Caution
• When mounting the unit on a wall, all
installation work must be performed
by a qualified contractor or dealer.
The customer must never attempt to
perform this installation work.
Improper or inadequate installation
could cause the unit to fall, resulting
in personal injury.