Operating Modes; Normal Mode - SEAL 62S Manual De Uso

5.2

Operating modes

The machine is either in normal mode, or slow mode. In both normal and slow mode the
rollers can rotate in forward or in reverse direction.
5.2.1

Normal mode

When slow mode is not activated (normal mode), the rotation speed of the rollers is set via
the speed control knob.
Start rotation by pressing the forward button, the reverse button or the footswitch.
Rotation stops when a stop button is pressed or the footswitch is released.
Note:
To return control from the footswitch to the control panel without stopping, press and
hold the forward button, release the footswitch and then release the forward button.
An interruption of the light beam of the optical safety device in front of the rollers will also
stop the rotation of the rollers. To continue after the interruption is taken away, the process
must be started again.
Reverse
WARNING:
KEEP CLEAR OF THE REAR SIDE NIP WHEN RUNNING IN REVERSE
MODE.
When running in reverse, the optical safety device at the front side nip is ignored and the
optical safety device at the output side is active.
The speed is determined by the speed control.
Operating 27