Synchronous Recording - Teac CD-RW890MKII Manual Del Usuario

The convenient synchronous recording function automatically starts
recording when receiving analog or digital signals from an externally
connected device such as a CD player and MD deck, and stops
recording when signal reception is complete .
For CD, MD, or DAT, synchronous recording starts when a digital
signal is detected, which is the beginning of a track . Synchronous
recording stops if there is a period where the sound is quieter than
the specified increment level lasting five seconds .
For digital sources other than the above or analog sources,
synchronous recording starts when a sound louder than the
specified increment level is detected . Synchronous recording stops
if there is a period where the sound is quieter than the specified
increment level lasting 8 seconds .
1
Load a recordable CD-R or CD-RW disc into the unit.
Press the OPEN/CLOSE (L) button, place a disc on the disc tray
with the disc label side up, and then press the OPEN/CLOSE (L)
button to close the disc tray .
2
Select the source to be recorded using the INPUT SELECT
button.
3
Select the mode of track number assignment using the
AUTO/MANUAL button.
20

Synchronous Recording

4
Press the SYNC 1/ALL button and select "SYNC 1" or "SYNC
ALL".
5
Press the RECORD button.
enters the record pause mode .
< The Play (y) button and Pause (J) button cannot be used during
synchronous recording .
6
Start playing the source.
< If no sound is heard for 5 seconds or longer during synchronous
recording, recording stops . To record the music with such periods
of silence, turn off synchronous recording . After turning off
synchronous recording, start recording manually, then play the
source to be recorded .
< Press the Stop (H) button to stop the recording manually .
< If you press the Stop (H) button or the Pause (J) button during
recording, the synchronous recording function will be cancelled .
< The synchronous recording function automatically turns off after
recording .
< The SYNC 1/ALL button cannot be used during recording or in the
record pause mode .
< When "SYNC ALL" is selected, the auto track function is always on .
Select –60, 50, 40 or 30 dB using the AUTO/MANUAL button .
< Even if the AUTO/MANUAL button is set to MANUAL, the auto track
function will be on during synchronous recording . The increment
level is set to –60 dB (–50 dB when recording via ANALOG) . The
setting automatically returns to MANUAL after the recording .
< In digital recording, synchronous recording may not start
depending on the digital source player . In such a case, start and
stop recording manually .
< To prevent the beginning of a track from being cut off, manually
start recording by pressing the Play (y) button before you play
the source to be recorded .
and J indicators on the display will light, and the unit