Preparation; Connecting Euroblock Plugs; Attaching The Bluetooth Antenna - Tascam MZ-123BT Manual Del Usuario

Preparation

Connecting Euroblock plugs

2.5 mm or less
Terminal screw
Euroblock plug tab
1.
Loosen the Euroblock plug terminal screws.
NOTE
Use a flat-blade screwdriver with a width of 2.5mm or less.
2.
Insert wires.
NOTE
AWG16-AWG28 wires are compatible with the included
Euroblock plugs. Using wires within the compatible range,
trim about 7 mm of the protective sheaths from their ends.
3. Tighten the Euroblock plug terminal screws.
NOTE
Confirm that the wires cannot be pulled out.
4.
Use an included wire band to attach the wires to the
Euroblock plug tab.
12
TASCAM MZ-123BT
Flat-blade screwdriver
Euroblock plug

Attaching the Bluetooth antenna

Before connecting to a Bluetooth device, follow these
procedures to attach the included Bluetooth antenna.
NOTE
When this unit is shipped new, a cap is attached to the
Bluetooth antenna connector. Remove the cap before
attaching the Bluetooth antenna.
Bluetooth antenna
1. Attach the included Bluetooth antenna to the Bluetooth
antenna connector.
2. Turn the Bluetooth antenna nut to secure it to the antenna
connector.
3. Raise the Bluetooth antenna.
ATTENTION
i Be careful to bend the antenna in the correct direction.
i Do not forcefully bend the antenna.
Nut
Bluetooth antenna connector