Mixing And Master Effect Zone - Numark NuVJ Manual De Referencia

If you right-click a cell and hold it for a little while, a pop-up
menu will appear with the following entries:
Clear Visual: Removes the visual from the cell
Clear Effect: Removes the effect from the cell
Reset Cell: Remove all settings, visual and effects from the cell
Import Bank: Imports a whole bank from a .nvjb file replacing
the bank to which the cell belong.
Export Bank: Allows to export all the bank to which the cell belong in a .njvb file.
Clear Bank: Clear the content of the bank. The clips are still kept in memory for further
access (through the visual library browser). To free the space used by clips not
selected in any banks, use the 'Purge Visuals' from the edit menu.

Mixing and Master Effect Zone:

The middle zone contains all the elements relative to master output and mixing processing. It
contains, from top to bottom:
Output Preview: The output preview duplicates the images sent to a second monitor when in full
screen mode. You can drag and drop browser element to the output preview. If you drag a Clip, a
Camera Source or Generator, that element will replace the background currently selected (see
background in the Concept section). If you drag an effect, that effect will be used as current Master
Effect.
Brightness and Contrast: These two controls allow correcting the contrast and brightness of the
image, either to adapt to the room lighting condition or to compensate the result of heavy
effecting.
Master Effect Section: The master effect section lets you apply an additional effect to the output of
the mixer. The effect can be selected using the combo box and three knobs below allow altering
the effect itself. The first one determines the wet/dry percentage between the original output and
the effected one while the two other allow modifying the specific parameters of the selected effect.
Crossfader: Controls the mixing between Deck A and
Deck B. On the far left it will only let through Deck A
in the output, while on the far right, only B will be
displayed. The way the image is mixed from A to B
depends on the transition used. Transitions can be
selected by right-clicking on the crossfader or by
using the configured switch on the control surface.
Note that the number
depends on the capabilities of your hardware.
of transitions available
17