Dremel 4200 Instrucciones De Funcionamiento página 15

The Dremel 4200 will work with a variety of
Dremel attachments including the attachments
included in the kit. Before purchasing an
individual Dremel attachment, always check for
the compatibility with the Dremel 4200. Please
note that the PL400 and MS400 attachments,
as well as some other older attachments, will
NOT fit on this rotary tool. When in doubt,
please contact customer service.
The adapter kit provided with your 4200 will
allow you to use the optional 225, 575 and 670
Dremel attachment.
INSTALLING ADAPTER
1. Remove accessory from the EZ Change™
chuck (Fig. 2).
2. Unscrew housing cap and remove from tool
(Fig. 11).
3. Insert drive coupling into the EZ Change™
chuck (Fig. 12).
4. Thread adapter onto the tool until tight
(Fig. 12).
INSTALLING OPTIONAL ATTACHMENTS
Make sure the square end of the center core of
desired attachment engages the square hole
Use only Dremel
WARNING
!
designed for this tool and may lead to personal injury or property damage.
The number and variety of accessories for the
Rotary Tool are almost limitless. There is a
category suited to almost any job you might
have to do — and a variety of sizes and shapes
within each category which en ables you to get
the perfect accessory for every need.
If you expect to use a variety of accessories,
we recommend that in the beginning you
purchase a complete set of four collets. Store
these so that you will have the proper size of
collet for any accessory or drill bit you want to
use. Currently, the 1/8", 3/32",1/32" and
1/16" collets accommodate all of the avail -
able Dremel accessories. 1/8" collets are
included in most rotary tool kits.
The collets used in the Dremel 4200 are
different from the ones used in any other
Dremel Attachments
Dremel Accessories
®
, high-performance accessories. Other accessories are not
Collets
socket in the driver coupling and thread
attachment onto end of adapter.
HOUSING
FIG. 11
Tighten
FIG. 12
Tighten
Loosen
Dremel Rotary Tool. Collets 480, 481, 482,
483 and 4485 cannot be used in the 4200.
A mandrel is a shank with a threaded or screw
head, which are required when you use
polishing accessories, cutting wheels, sanding
discs, and pol ish ing points. The reason
mandrels are used is that sanding discs,
cutting wheels and similar accesso ries must be
replaced frequently. The mandrel is a per -
manent shank, allowing you to replace only the
worn head when necessary, thus saving the
expense of replacing the shaft each time.
Screw Mandrel N° 401
This is a screw mandrel used with the felt
polishing tip and felt polishing wheels. 1/8"
shank.
15
CAP
Loosen
ADAPTER
DRIVE
COUPLING
Mandrels