6.3. COUNTER FUNCTION
The display stores the total number of cycles* completed. To visualize the figure, with the machine
stopped and in stand-by, press the STOP button. The figure will appear on the display for a few
seconds.
Bear in mind that all machines show a minimum of 200 to 250 cycles completed for quality control
testing.
The display is limited to seven digits, making it so a maximum of 9.999,999 cycles can be displayed.
*(cycle = complete set of movements to squeeze a piece of fruit)
6.4. AUTOMATIC START FUNCTION
Turn off the machine at the mains.
With the machine turned off, press STOP, keep it pressed and turn the machine on at the mains; keep
it pressed for 4 seconds and the display will show four numbers.
When you have reached this point, look for the number 4104; by pressing ON you control the two digits
on the left and by pressing SELECT you control the two digits on the right; then press STOP (when
you press STOP the display will show ----) and then turn off the machine at the mains (if the machine
is not switched off, it cannot leave this screen display).
When you turn on the machine again (first you see the programme version and then the number 4104),
it will start operating when the photocell detects fruits and will continue operating until the fruits are
finished or you press STOP.
•
If it stops when the fruits have finished, you simply need to put more fruits on the ramp to put
the machine back into operation.
•
If you press STOP, the machine will stop and the fruits will remain on the ramp. To turn the
machine back on again:
-
Remove the fruit on the ramp and then put them back again or press ON.
Important: keep the lens of the photocell clean to ensure it can visualize the fruit properly (Fig. 4).
TO RETURN TO THE STANDARD OPERATING SYSTEM.
Repeat the process by entering code 1001.
6.5. FINAL OPERATION SIGNAL
To activate the beep signal, repeat the 6.4. section process by entering the code 8548. After
connecting
the
machine
TO DEACTIVATE THE BEEP SIGNAL
Repeat the process by entering the code 8549.
when
the
machine
finish
a
service
the
machine
beeps.
30