HYGIENE WHEN BEING REUSED:
When the chair is to be reused, it should be prepared carefully, and
be wiped and treated with spray disinfectant on all surfaces which
could come into contact with the user.
If you need to do this quickly, you must use a liquid, alcohol-based
disinfectant suitable for medical products and devices.
Please pay attention to the manufacturer's instructions of the
disinfectant you are using.
Trouble shooting
Wheelchair pulls to one side
• Check tyre pressure
• Check to make sure wheel turns easily (bearings, axle)
• Check the castor angle
• Check to make sure both castors are making proper contact with
the ground
Castors begin to wobble
• Check the castor angle
• Check to make sure all bolts are secure; tighten if necessary (see
the section on torque)
• Check to make sure both castors are making proper contact with
the ground
Wheelchair squeaks and rattles
• Check to make sure all bolts are secure; tighten if necessary (see
the section on torque)
• Apply small amount of lubrication to spots where movable parts
come in contact with one another
Wheelchair begins to wobble
• Check angle at which castors are set
• Check tyre pressure
• Check to see if rear wheels are adjusted differently
Disposal / recycling of materials
NOTE: If the wheelchair has been supplied to you free of charge it
may not belong to you. If it is no longer required follow any
instructions given by the organisation issuing the wheelchair in order
that it may be returned to them.
The following information describes the materials used in the
wheelchair in relation to the disposal or re-cycling of the wheelchair
and its packaging.
Specific waste disposal or recycling regulations may be in force
locally and these should be taken into consideration when disposal
arrangements are made. (This may include the cleaning or
de-contamination of the wheelchair before disposal).
Aluminium: Castor forks, wheels, side frames, armrests, frame, leg
rests, push handles
Steel: Fasteners, QR axle
Plastic: Handgrips, tube plugs, castor wheels, footplates, armpads
and 12" wheel/tyre
Packaging: Low density polythene bag, cardboard box
Upholstery: Woven polyester with PVC coatings and expanded
combustion modified foam.
Disposal or recycling should be done through a licensed agent or
authorised place of disposal. Alternatively your wheelchair may be
returned to your dealer for disposal.
Technical Data
Overall width:
• With standard wheels including handrims, close mount:
:
2
RubiX
• With drum brake wheels including handrims, close mounted:
:
RubiX
2
Folded dimensions:
• With standard wheels:
:
2
RubiX
• Without standard wheels:
:
2
RubiX
Maximum load:
• RubiX
2
• Reinforced version RubiX
2
Weights in kg:
• Transportation (without footrest, wheels, sideguard)
• Transportation RubiX
XL , (without footrest,
2
wheels, sideguard):
• Footrest (unit):
• Standard sideguard (unit):
• 24" rear wheels (solid) (pair):
Maximum occupant mass (test dummy mass): 125 kg, (XL= 170kg)
ALSO SEE PAGE 4
In Accordance with EN12183: 2009 all there listed parts (seat - back
upholstery, arm pad, side panel...) are fire resistant as per EN1021-2 .
The Dynamic safe slope is dependant on the chair configuration, the
users abilities and the style of riding. As the users abilities and style of
riding cannot be predetermined then the max safe slope cannot be
determined. Therefore this must be determined by the user with the
assistance of an attendant to prevent tipping. It is strongly
recommended that inexperienced users have Ant-tips fitted.
The wheelchair conforms to the following standards:
a) Requirements and test methods for static, impact and fatigue
strengths (ISO 7176-8)
b) Requirements for resistance to ignition in accordance with ISO
7176-16 (EN 1021-1)
Torque
Unless otherwise advised, the torque for M6 screws is 7 Nm.
Please refer to page 5 for detaials
Seat Height Adjustment
Please refer to the table on page 5.
SW +19 cm
SW +21 cm
30 cm
24 cm
up to a load of 125 kg
XL
up to a load of 170 kg
8.4 kg
11.4 kg
0.8 kg
0.8 kg
3.8 kg
RubiX
2
91