Important; Fan Mounting - Harbor Breeze E-BLHII52VPW5C4S Manual De Instrucciones

INITIAL INSTALLATION
4.
Secure mounting bracket (C) to outlet box using
screws, spring washers, and flat washers
provided with the outlet box. (Fig. 4)
*NOTE: It is very important that you use the
proper hardware when installing the mounting
bracket (C) as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (C) is installed
facing the higher point of the ceiling.
5. Remove motor screws (K) and lock washers (L)
from underside of motor and save for blade arm
(H) attachment later on. [If there are plastic motor
blocks installed with the motor screws (K) and
lock washers (L), discard the plastic motor
blocks.] (Fig. 5)

FAN MOUNTING

Remove pin (N) and clip (O) from motor housing
1.
yoke at top of motor housing (D) and partially
loosen set screws. (Fig. 1)
*Helpful Hint: Downrod style mounting is best
suited for ceilings 8 ft. (2.44 m) high or higher.
For taller ceilings you may want to use a longer
downrod (not included) than the one provided.
Angle style mounting is best suited for angled or
vaulted ceilings. A longer downrod is sometimes
necessary to ensure proper blade clearance.
4
C
5
1
O
D
E
7
K
L
L
D
Set
Screw
N