FAN MOUNTING
Insert downrod (A) through canopy (B), canopy
2.
cover (T), and yoke cover (F). [Note: Canopy
cover (T) must be turned with the shiny side
toward the motor housing (D).] Thread wires
from motor housing (D) through downrod (A).
(Fig. 2)
Slip downrod (A) into motor housing yoke, align
3.
holes and re-install pin (N) and clip (O).
Re-tighten set screws in motor housing yoke and
then tighten nuts. Slide yoke cover (F) down until
it rests on top of motor housing (D). (Fig. 3)
4.
Depending on the length of downrod (A) you
use, you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested that you do so in the
following manner:
Take the lead wires and make sure that you
have pulled them all the way through the top of
the downrod (A). Start at the TOP of the ball on
the downrod (A) and measure 8 in. of lead wire,
and then cut the excess wire off with wire cutters
(not included). (Fig. 4)
Note: If you do not cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead.
2
A
B
F
3
A
O
D
4
8
T
F
Set Screw
N
Ball
A