Memory - Displaying The Last Measurement; Discontinuing A Measurement - CVS Pharmacy 271245 Instrucciones De Uso

b) After automatically reaching an individual pressure,
the pump stops and the pressure slowly falls. The cuff-
pressure is displayed during the measurement.
c) When the device has detected your pulse, the heart
symbol in the display begins to blink and a beep tone
is audible for every pulse beat.
d) When the measurement has been concluded, a long
beep tone sounds. The measured systolic and diastolic
blood pressure values as well as the pulse are now
displayed.
e) The measurement results are displayed until you
switch the device off. If no button is pressed for
5 minutes, the device switches off automatically.
5.5. Memory – displaying the last measurement
The measured results are stored in the instrument until a new
measurement is carried out or the batteries are removed.
You can call up the stored values at any time by pressing the
MEMORY button for at least 3 seconds.

5.6. Discontinuing a measurement

If it is necessary to interrupt a blood pressure
measurement for any reason (e.g the patient feels unwell),
the On/Off button can be pressed at any time. The device
then immediately lowers the cuff pressure automatically.
Further information
Measurements should not occur soon after each other,
since the results will be innacurate. Wait several minutes
in a relaxed position, sitting or lying, before you repeat a
measurement.
MR
10