Publicidad
Idiomas disponibles
Idiomas disponibles
AIRMAX
Only use this charger with batteries that meet the specifications on the chart below: Connect its DC output plug to the battery and
then connect its AC input plug to 100-240VAC mains power before switching on the mains power point; ensure the charging lights are
illuminated.
It is normal that the charger and the battery might warm up (below 50°C) during charging; otherwise please stop using it. Please
disconnect the charger AC input plug first and then disconnect the DC output plug when charging is finished. The red LED shows that
the batteries are still charging. The green LED indicates that the battery is fully charged and ready for use. Do not leave the battery
charger in the power supply when not in use.
Safety
Do not charge any other batteries than the specified in this manual. Don't use the charger if it shows visible damage. Do not attempt to
repair the charger, this will end the warranty and will increase the accident and/or damage. Never expose the charger to water, rain or
snow. Contact your supplier if charger replacement is needed.
Environmental disposal
Batteries are chemical waste, dispose them in a special container or hand them in at an authorized recycling centre.
PACKAGING / LABELING
Lot Code Description: GLyjjj-xxxx (e.g. GL0013-0005)
GL
= Manufacturer identifier
y
= Last digit of year of production (e.g. 0 for 2020)
jjj
= Julian (sequential) day of production (e.g. 013 for January 13)
xxxx = Last four digits of purchase order number (e.g. 0005)
TECHNICAL DATA
This powered respirator is light-weight and easy to handle. It is equipped with a replaceable particulate filter. The system affords
reliable protection against particulates and aerosols.
Air flow: 170 to 210 lpm. Minimum flow rate 170 lpm
Weight with filter: 700 g
Operating temperature between 0°c and +40°c
Type of filter: P3 R SL
Type of Battery: Replaceable and rechargeable Li-Ion 7.4V/5200mAh
Charging Cycles >350
Visual alarm for low battery voltage.
Visual, audible alarms and Vibration alarms for insufficient flow rate (below 170lpm)
Nominal Protection Factor (NPF) 500
Noise level: 70dBA
Operating time greater than 8 hours on minimum flow rate with a new filter and fully charged battery in a clean environment at room
temperature.
Note! Operating time can be shortened in case of clogged filter under changed battery
EU DECLARATION OF CONFORMITY:
charger - J7067
®
https://www.jacksonsafety.com/europe-products-documentation
•
Operational range:
100Vac – 240Vac
•
Frequency:
50-60Hz at 150mA
•
Operating temperature range:
0°C to 40°C
•
Operating relative humidity:
8% to 85%
•
Initial charge before first use of batteries:
8 hours
Technical Specifications
10
Publicidad
