IMPORTANT: Before starting programming, it is important to select the appropriate operation mode. Check point 6.6.1. Change
operation mode of this manual and choose one of these modes: PI PRESS+RTC, PI VOLUME+RTC, PROPORT.+RTC or MIN-
MAX+RTC.
When one of these modes is selected, start programming with following sequence:
+ 3"
DATE:
14/01/15
HOUR:
12:28
EXIT?
CONT
YES
MONDAY
T1
09:00
MONDAY
T2
11:00
MONDAY
T3
14:00
Press for 3 seconds
Date introduction
Increase / Decrease value
OK
OK
Forward / Back
Time introduction
OK
OK
30
Pressing on
YES
Pressing on
CONT
OK
OK
Start time for period frame T1 on Monday
OK
OK
Start time for period frame T2 on Monday
OK
OK
Start time for period frame T3 on Monday
OK
OK
54
, back to main screen
, continue programming