Automatic Buttonhole - Janome Magnolia 7325 Manual De Instrucciones

q
r
t
q
z
x
(A)
e
(B)
r
w
e
w

Automatic Buttonhole

Machine setting
q Stitch pattern: BH
w Stitch width:
4 – 5
e Stitch length:
0.5 – 1
r Thread tension: A
t Presser foot:
Automatic buttonhole foot R
NOTES:
The size of buttonhole is automatically determined by
placing the button in the automatic buttonhole foot.
The button holder of the foot takes a button size up to 1"
(2.5 cm) in diameter.
Make a test buttonhole on a sample duplicating the
fabric, interfacing and seams of the actual garment to
check the settings.
Use interfacing on stretch fabrics.
Turn the handwheel toward you to raise the needle to its
highest position.
z Place the automatic buttonhole foot with the pin lies
just under the groove on the foot holder. Lower
the foot lifter to snap the foot in place.
q Groove
w Pin
x Pull to open the button holder to the back (A), and
place the button in it. Push back (B) the button
holder against the button to hold it tight.
e Button holder
NOTE:
For thick buttons, make a test buttonhole. If the button
does not fit through the test buttonhole, lengthen the
buttonhole by pulling the button holder a little to the
back.
r Pull a little
50