TUBES ASTRO Manual De Uso página 15

flow of hot air ((about 1000W – MEDIUM
power);
• Touch the MODE control
1 second: the LED turns ORANGE and
the device emits a strong flow of hot air
(about 1200W – MAXIMUM power);
•Touch the MODE control
1 second: the LED turns BLUE again.
The device switches back to ventilation/
sanitizing mode only.
To exit each of these modes, you only
have to switch the device back to
stand-by mode by touching the ON/OFF
control . Heating stops immediately,
while ventilation continues for 2 minu-
tes to cool the temperature inside the
device. When this time has ended, the
top shelf is automatically lowered and
the device enters stand-by mode.
• 2 hr BOOST mode
The 2 hr boost mode turns on the hea-
ting of the device at MAXIMUM power
(32°C) for a total of two hours from
when the boost mode starts. When this
time has ended, the device will auto-
matically return to the previous heating
mode.
It is turned on using the following pro-
cedure:
• Touch the MODE control
seconds, after which the device will
emit a beep indicating the correct
turning on of the Boost mode. The LED
turns DARK RED. This function can be
turned on during any of the heating
modes described above.
There are two ways to exit this mode
before the two hours are up:
• Return to the heating mode set befo-
re Boost by touching the MODE control
again for 4 seconds. In this case too,
a beep will be heard indicating that
it has correctly returned to the mode
previously set;
• Switch the device back to stand-by
mode by touching the ON/OFF
cod. MAN#AST - Settembre/September 2019
control
Wi-Fi and PLUG&PLAY APP
CONFIGURATION
again for
You can control the temperature of
your home when you are away from
it, thanks to the TUBES Plug&Play app.
again for The TUBES Plug&Play app allows you to
turn your Astro on or off, raise or lower
and programme its temperature direct-
ly from your smartphone, at any time
and wherever you are.
The device has its own Wi-Fi
network known as "TUBES ASTRO
- XXXXXXXXXXXX" (where the Xs cor-
respond to the MAC address of the
Wi-Fi module inside the device). This
network allows it to connect to the
home Wi-Fi network and be program-
med remotely.
How to set up the Astro Wi-Fi network
When first switched on,the device au-
tomatically performs the Wi-Fi network
set-up.
The two LEDs on the body of the device
emit a WHITE light for 10 seconds until
set-up is complete. Astro then goes into
stand-by mode and the user can select
the desired operating mode.
• If, for any reason, the set-up is not
for 4
successful, the device will automatically
repeat this procedure the next time the
device is switched on.
• When it is first switched on, Astro's
default settings are as follows:
• Temperature set: 32°C
• Open window detection: off
• Programme times:
• Wi-Fi on and in access point mode.
The network is called "TUBES ASTRO
.
MON-FRI
SAT-SUN
06:00-09:00;
11:00-14:00;
07:00-24:00
17:00-24:00
15