TUBES ASTRO Manual De Uso página 16

- XXXXXXXXXXXX", where the Xs corre-
spond to the MAC address of the Wi-Fi
module.
When switched on subsequently, the
device automatically connects to the
Wi-Fi network with the settings entered
when the app was last used
How to Enable/Disable the Astro Wi-Fi
network
If you wish to disable the Astro Wi-Fi
network, you must unplug the device
and then plug it back in again. Imme-
diately after plugging it back in, touch
both touch controls at the same time
for 5 seconds, as soon as the two white
LEDs light up.
After 5 seconds, Astro emits a beep, si-
gnalling that the two touch controls can
be released. If the network has been
successfully disabled, 3 beeps will signal
that the Wi-Fi is now switched off.
Use the same procedure if you wish to
switch the Astro Wi-Fi network back on
again. After 5 seconds, Astro emits a
beep, and you can release the controls.
If the operation has been successful, 2
beeps will signal that the Wi-Fi is now
switched on.
TUBES Plug&Play App
Perform the following steps to connect
the Astro network to your home Wi-Fi
network:
• Download the TUBES Plug&Play app
from Google Play or the App Store
of your smartphone. In the meanti-
me, make sure that your home Wi-Fi
network is switched on.
(The home Wi-Fi connection to whi-
ch the device is to be connected must
allow TCP connections towards the
exterior, via the 12345 port. For 99%
of home Wi-Fi connections, this is the
default setting.)
• Open the app and access your cre-
dentials. On your first access, register
16
by entering a User Name, an e-Mail
address and a Password as requested.
• Exit the app temporarily and access
your phone's Wi-Fi Settings. Connect to
the Astro network called "TUBES ASTRO
- XXXXXXXXXXXX". The Xs will be repla-
ced by a series of digits that identify the
Astro Wi-Fi network.
NB: it is essential to access the app BE-
FORE connecting to the Astro network:
therefore you must open the app on
your smartphone; only after doing so
can you search for the Astro network.
Inverting these two steps may cause
problems.
• Once your smartphone is connected
to the Astro network, go back to the
app and click the settings icon on the
top right of the screen. Click "Configu-
re the Wi-Fi" to connect Astro to your
home network.
• Select your home network from the
list of available networks, enter the
password for the selected network and
wait for Astro to be correctly configured
for the network.
• Then return to the app's home page
and click "Add". Scan the QR code of
your Astro on the label on the device
and rename the device as you wish.
• Astro is now shown in OFFLINE mode.
Connection of the networks and swi-
tching to ONLINE mode may take a few
seconds. After this has been completed
you can begin using Astro from remote
via the TUBES Plug&Play App.
This procedure is required every time
a new Tubes Plug&Play product is
used, or if you change your home Wi-
Fi network, or following a reset of the
product's settings. You can use more
than one Tubes Plug&Play device remo-
tely via the app.
The TUBES Plug&Play App also allows
you to make the most of all the Astro
features previously described. Addi-
cod. MAN#AST - Settembre/September 2019