Turning The Saw On And Off - Delta 96-107 Manual De Instrucciones

Turning the Saw On and Off

Connect the unit to a power source with the correct voltage
and frequency (120v).
1.To start the motor; pull the switch (C) to the "ON" position.
2. To stop the motor: push the switch to the "OFF" position.
NOTE: Providing the pump's plug is inserted into the pump
plug receptacle on the motor, the pump will be turned on when
the motor is turned on.
Using the Safety Lock
When the saw is not being used, the ON/OFF switch should
be locked with the OFF position, using a long shackle pad lock
with a 3/16" diameter shank.
To lock the saw:
1. Insert the shackle through the hole located underneath
the switch and pass it all the way through the lock tab on the
switch and out the other side.
2. Secure the lock.
3. Store the key in a secure place and away from the saw
OPERATION
13
Figure 18