Cleaning And Care; Replacing The Light Bulbs; If You Encounter A Problem - NEFF D96W44N0 Instrucciones De Uso

Cleaning and care

Isolate the extractor hood by pulling out the
mains plug or switching off the fuse.
q When cleaning the grease filters, remove
grease deposits from accessible parts of the
housing. This prevents the risk of fire and en-
sures that the extractor hood continues operat-
ing at maximum efficiency.
q Clean the extractor hood with a hot soap solu-
en
tion or a mild window cleaner.
q Do not scrape off dried-on dirt but wipe off with
a damp cloth.
q Do not use scouring agents or abrasive spong-
es.
q Note: Do not use alcohol (spirit) on plastic sur-
faces, as dull marks may appear.
Caution: Ensure that the kitchen is adequately
ventilated. Avoid naked flames!
Clean the operating buttons with a mild soapy
solution and a soft, damp cloth only. Do not use
stainless-steel cleaner to clean the operating but-
tons.
Stainless steel surfaces:
q Use a mild non-abrasive stainless steel cleaner.
q Clean the surface in the same direction as it
has been ground and polished.
Do not use any of the following to clean stain-
less steel surfaces: abrasive sponges, cleaning
agents containing sand, soda, acid or chloride!
Aluminium and plastic surfaces:
q Use a soft, non-linting window cloth or micro-
fibre cloth.
q Do not use dry cloths.
q Use a mild window cleaning agent.
q Do not use aggressive, acidic or caustic clean-
ers.
q Do not use abrasive agents.
20

Replacing the light bulbs

1. Switch off the extractor hood and pull out the
mains plug or switch off the electricity supply at
the fuse box.
When switched on, the halogen bulbs become
very hot. Even for some time after the bulbs have
been switched off there is still a risk of burns.
2. With the aid of a screwdriver pull out the bulbs
or, if it is not easy, remove the 2 screws fixing
the Lighting support, and pull it out of from the
Hood.
3. Replace the halogen light bulb (conventional
halogen bulb, 12 Volt, max. 20 Watt, GU4 bulb-
holder).
Caution: Plug-in bulbholder.
4. Replace the Support, fixing it in place with the
two screws removed as above.
5. Restore the power by inserting the mains plug
or switching on the fuse.
Note: If the light does not function, check that the
bulbs have been inserted correctly.

If you encounter a problem

If you have any questions or if a fault occurs, please
call Customer Service.
(See list of Customer Service representatives).
When you call, please quote the following:
E-Nr.
Enter the relevant numbers into the box above. The
E-Nr. (product no.) and FD (production date) are
shown on the nameplate which can be seen inside
the extractor hood after the filter frame has been
detached.
The manufacturer of the extractor hoods
accepts no liability for complaints which can
be attributed to the design and layout of the
pipework.
FD