Installation; Placement; Safety Measures From Standpoint Of The Fire Protection Act. No. En 061008 Coll. 12 - Lotus BR 50-78 ET Instrucciones Para La Instalación

•
manufacturer reserves the right refuse any responsibility in case of damages caused by wrong
installation, by disobeying of above mentioned recommendations or by violation of the rules of the
use
Important:
The manufacturer does not provide warranty for defects caused by improper use, failure to instructions
contained in the attached instructions for use and mistreatment of the appliances.
Installation, adjustment and repair of appliances for kitchens, as well as their removal because of possible
damage to the gas can be carried out only under a maintenance contract, this contract may be signed with
an authorized dealer, and must be complied with regulations and technical standards and regulations
regarding the installation, power supply, gas connection and health & safety system.
These instructions are intended for the qualified technician who must perform the installation, put it into
operation and test the appliance.
Any activity as settings, placement, rebalancing etc, must be made only when is device disconnected from
electricity and gas feeder. If it is necessary to have the device connected to the electricity or to gas feeder,
you must keep the highest attention to avoid any injuries.
The appliance may only be installed in permanently ventilated rooms, as specified by the standard TPG G
704 01, EN 127040 and EN 127010. In the room where the appliance is installed, there must be an
adequate air flow to meet the requirements of normal combustion of gas and the necessary ventilation of
the room itself. The room must be kept adequately ventilated in order to eliminate the heat and humidity
produced by cooking: in particular, after prolonged use, it is recommended to open window or to increase
the speed of ventilators.
If the device will be situated close to the wall, or if it will be in contact with the furniture walls, those walls
must resist temperatures ranging to 60°C. Installation, settings, putting into operation must be made by
qualified technician who is competent for this.
Extract the device and check whether it was not damaged during transport. Settle the appliance down on
horizontal surface (max. allowed imbalance 2 °C).
The device can be installed separately or in a set with other devices from our production. Minimal distance
10 cm from other subject must be kept.
This product cannot be installed in contact with combustible materials and must be installed or
stand on non combustible surface.

Safety measures from standpoint of the fire protection Act. No. EN 061008 COLL. 12

• The appliance is designed for use by adults
• Appliance may be safely used in a normal environment by Act No. EN 332000-1
• Appliance must be placed so as to stand on the non combustible surfaces

Installation

Placement

7